After
the exterior is washed, dried, and dressed, begin working on the interior.
Interior care consists of: de-trashing, vacuuming, cleaning, dressing
and vinyl/leather conditioning.
|
|
DE-TRASH & VACUUM
Remove all trash. Empty all ashtrays. After removing the floor mats,
vacuum out the interior and trunk, using care to reach under seats
and in crevices. Use a brush
to help loosen carpet fibers when vacuuming. Shake any loose dirt from the
floor mats, then vacuum them as well.
|
|
CLEAN ALL VINYL/LEATHER
Dilute 1 part #8B E-Z Clean HD to 30 parts water and mist on
vinyl/leather dashboards, headliners, sunvisors, door panels,
steering wheel, center consol, etc. If needed, use a soft
brush to agitate the product in heavily soiled areas. Wipe dry
with a clean, soft towel. |
|
DRESS THE VINYL
To restore original beauty to vinyl upholstery, dashboards, door
panels, air vents, and other vinyl parts, use #65 Super Dress-It®
at full strength. Spray or wipe the product with an applicator
pad, then wipe dry with a soft, clean towel. |
|
CONDITION THE LEATHER
Condition and protect the interior leather (if applicable) with #58
Leather Conditioner. Leather
Conditioner will penetrate quickly to restore suppleness, gloss and
texture. Pour a small amount of
Leather Conditioner on to an applicator pad, then apply to the
surface using overlapping, circular motions. Remove excess with a
soft, clean cloth. Repeat process if necessary. Do not apply to
suede. |
|
CLEAN CARPETS & SEATS
For use in a mist sprayer, dilute 1 part E-Z Clean-HD to 30 parts
water. Spray product directly on surface, then agitate with a nylon
brush. Remove with a soft, clean towel or wet-dry vacuum. When using
a 5 gallon pail, pour 4 oz. of product into bucket, then fill using
high pressure. Use a carpet brush to apply product to the area, then
remove with a wet/dry vacuum. Do not over-saturate the seats, mats
and carpet when cleaning. They should be almost dry when completing. |
|
STAIN GUARD THE UPHOLSTERY
Make sure upholstery is completely dry. Using #39 Stain Guard, mist
evenly and allow to dry. Repeat process if desired. Do not saturate
the area. Not for use on leather, vinyl or hard plastic.
Now you're ready for Task 4: PAINT
CLEANING & WAXING,
click here to go there.
|
|
Recommended
Auto Magic® Products:


Contact your local
Auto Magic®
Distributor for sizes larger than
16 Ounce and additional products. Click here to find your
local Auto Magic®
distributor. |
|